How to Fill Nail Holes in Wood or Drywall
After installing molding, the wood is riddled with small holes (if it's not, you didn't set your nails deep enough). Touching up the nail holes is easy, but can be tedious. This same technique can be used to fill nail holes in drywall- these holes may be visible if you move or remove a picture. For wood, use wood filler (e.g. Elmer's). For drywall, use spackling (e.g. DryDex).
If you are filling holes on an uneven surface or if you are only filling a couple of holes, use your finger. put a small amount of wood filler or spackling on the tip of your finger and gently work it into the hole. Leave a little bit of excess- you will sand it once it is dry.
If you are filling many holes on a flat surface, I find it easier to use a small putty knife. Put a small amount of wood filler or spackling on the putty knife and spread it over the hole. Remove most of the excess with the knife and use it on the next hole.
Once everything has dried, run a sanding sponge over each area and then paint or touch up.
Jon
P.S. If you found this post helpful, give it a Digg. Thanks.
Did you enjoy this post? Why not leave a comment below and continue the conversation, or subscribe to my feed and get articles like this delivered automatically to your feed reader.
Comments
No comments yet.
Leave a comment